Skip to main navigation Skip to search Skip to main content

Impact of fine divertor geometrical features on the modelling of JET corner configurations

  • Līga Avotiņa (Member of the Working Group)
  • , Larisa Baumane (Member of the Working Group)
  • , Mihails Haļitovs (Member of the Working Group)
  • , Juris Jansons (Member of the Working Group)
  • , Gunta Ķizāne (Member of the Working Group)
  • , Ričards Kovaldins (Member of the Working Group)
  • , Andris Leščinskis (Member of the Working Group)
  • , Broņislavs Leščinskis (Member of the Working Group)
  • , Elīna Pajuste (Member of the Working Group)
  • , Aigars Vītiņš (Member of the Working Group)
  • , Artūrs Zariņš (Member of the Working Group)
  • , Tamain P.
  • , JET Contributors

    Research output: Contribution to journal › Article › peer-review

    1 Citation (Scopus)

    Abstract

    The modelling of JET corner configurations, in which the strike points are positioned deep in the corners of the divertor, is extremely challenging for edge plasma fluid modelling tools. To circumvent this technical limitation, a geometrical approximation has been proposed, consisting in considering an artificial minor modification of the geometry of the divertor targets plates. In this paper, we investigate how significantly this approximation impacts the output of transport simulations. Using the SOLEDGE2D-EIRENE transport code which has the unique capability to be able to cope with both the full and the approximated geometry, we have performed a density scan in H-mode for pulses in which the outer strike-point lies in the corner of the divertor. We report here how simulations in the artificial geometry differ from the ones in unaltered geometry. At the exception of low density cases, mid-plane profiles in the closed field lines region and the near scrape-off layer are little impacted. Further out however, in flux-surfaces that are concerned by the geometrical modification, we find that modifying the geometry leads to a strong overestimate of the plasma density. The density perturbation is not local and concerns the whole flux surfaces. Although the divertor geometry is modified only on the outer side, the largest impact is found at the inner divertor where densities are systematically overestimated by a factor that can exceed 10 in low density cases in the far Scrape-Off Layer (SOL) and temperature underestimated by 10 to 20 eV in most of the studied density range. The near SOL and strike point peak values are also impacted in the same direction with density changes by a factor of 2. As a consequence, the threshold to detachment of the inner divertor is found lower in the approximate geometry than in the unaltered one. Due to the large flux expansion between the outer and the inner target, the difference in plasma is especially sensitive at the top of the inner divertor baffle, which could have consequence on the evaluation of physical sputtering at that critical location.

    Original languageEnglish
    Article number100989
    JournalNuclear Materials and Energy
    Volume27
    DOIs
    Publication statusPublished - Jun 2021

    UN SDGs

    This output contributes to the following UN Sustainable Development Goals (SDGs)

    1. SDG 7 - Affordable and Clean Energy
      SDG 7 Affordable and Clean Energy

    OECD Field of Science

    • 1.3 Physical Sciences

    Keywords

    • Corner
    • Edge
    • Fluid
    • Modelling
    • Plasma
    • Tokamak

    Fingerprint

    Dive into the research topics of 'Impact of fine divertor geometrical features on the modelling of JET corner configurations'. Together they form a unique fingerprint.

    Cite this